Caution
If the product generates a strange noise, a
If water or a foreign substance enters the
product, turn the product off, unplug the
power cord from a wall outlet, and contact
a Service Center.
burning smell, or smoke, unplug the power
plug immediately and contact a service
center.
•
Failing to do so may result in electric
shock or fire.
If the power plug pin or jack is exposed to
dust, water or alien substances, clean it
thoroughly.
Do not use the product while it indicates a
malfunction, such as no sound or no pic-
ture.
•
There is a danger of electric shock or
fire.
•
Turn the product off immediately,
unplug the power cord from a wall
outlet, and contact a Service Center.
When cleaning the product, disconnect the
power cord and clean the product with a
soft dry cloth.
When a gas leak occurs, do not touch the
product or the power plug and ventilate
immediately.
•
Avoid using chemicals such as wax,
benzene, alcohol, thinner, mosquito-
repellent, fragrance, lubrication or
cleansing agent when cleaning the
product.
•
A spark may result in an explosion or
fire.
•
During a thunder or lighting storm, do
not touch the power cord or antenna
cable
This may result in the exterior being
deformed or the print being removed.
When not using the product for a long
time, such as leaving your home, unplug
the power cord from the wall outlet.
Do not touch the lens on the product.
This may cause damage to the lens.
•
•
Otherwise, it may cause dust
accumulation and result in fire caused
by overheating or a short circuit or
result in an electric shock.
If the product is installed in a location
where the operating conditions vary con-
siderably, a serious quality problem may
occur due to the surrounding environment.
In this case, install the product only after
consulting our Call Center.
Do not touch any outer part of the product
with tools such as a knife or a hammer.
•
Places exposed to microscopic dust,
chemicals, too high or low temperature,
high humidity, such as airports or
stations where the product is
continuously used for a long time etc..
If you drop the product or the case is dam-
aged, turn the power off and unplug the
power cord. Contact a service center.
To clean dirt or stains on the front projec-
tion lens, use spray or a wet cloth damp-
ened with neutral detergent and water.
•
Failing to do so may result in fire or
electric shock.
Make sure to place your remote control on
a table or desk.
Ask a Service Center to clean the interior
of the projector at least once per year.
•
If you step on the remote control, you
may fall and hurt yourself or the
product may be damaged.
Major Safety Precautions
1-3
