KV-28FX65U
KV-32FX65U
Checking the
accessories supplied
Connecting the TV
R
3
1
2
Connecting an aerial to your TV
If you are not
connecting your TV
to a VCR, please
connect the aerial
lead (as shown left)
and proceed to
Thank you for purchasing this Sony product.
section ‘4.Switching
on the TV’.
After following this step by step guide you
will be able to:
If you are connecting
your TV to a VCR
please refer to the
section below.
Insert batteries into the remote control.
Connect the aerial to your TV.
Batteries
Connect a video cassette recorder (VCR)
to your TV.
Connect your existing aerial lead to the socket marked
on the rear of the TV set.
Tune your TV.
Connecting an aerial and VCR to your TV
View TV programmes.
Remote Control
The scart lead is
optional. If it can be
used however, this
additional
connection can
Inserting batteries into
the remote control
improve picture and
sound quality when
in play mode.
OUT
IN
AERIAL
ANTENNA
AC IN
1. Connect your existing aerial lead to your VCR as shown.
2. Connect the VCR aerial lead from the RF OUT socket on the back of the VCR to the
aerial socket on the back of the TV as shown.
3. Connect the scart lead (if used) to the AV2 socket on the rear of the TV set.
4. Connect the VCR set to the mains and switch on.
5. Insert a pre-recorded tape into the VCR and press the ‘PLAY’ button. This enables the
TV set to locate and store the video channel during the ‘Automatically Tuning the TV’
section of this Quickstart Guide.
Always observe the correct polarity when inserting batteries.
Always remember to dispose of used batteries in an environmentally friendly way.
4-205-798-03
|